GE LOGIQ E10 Basic Service Manual page 658

D 5750007-1EN, R
IRECTION
Calibration and adjustments
No calibrations or adjustments are needed after this part replacement.
Verification
Perform the following steps to verify that the product is functioning as intended after this replacement:
1.) Verify that all screws that you removed earlier have been installed.
2.) Connect cables and probes removed earlier.
3.) Power up the system to verify that it operates as intended.
Functional Checks
Perform the following functional tests to confirm the system is operational before returning the system
to the customer.
See
Section
4-2-3
4-2-7
4-2-7
4-2-7
4-2-4
8 - 412
. 1
EV
Table 8-406 4D Option replacement Checks
Functional Check
Power ON/Boot Up
Probe/Connectors Checks
B-Mode Checks
System CFM and PWD Checks
Perform a 4D sweep
Power SHUT DOWN
Section 8-16 - Options replacement
LOGIQ E10 B
Debrief Script
LOGIQ E10 Basic Service Manual, Direction
5750007-1EN. Equipment passed all required
tests and is ready for use.
S M
ASIC ERVICE ANUAL