GE LOGIQ E10 Basic Service Manual page 203

D 5750007-1EN, R
IRECTION
6-4-3 Adjusting the XY Locking Mechanism
Table 6-9
1.
This procedure is intended to adjust the
locking mechanism for the XY Assembly.
Locate hex screw behind the XY Assembly
to adjust it correctly.
Use a 3 mm hex wrench to adjust. Rotating
the screw clockwise will tighten and
rotating the screw counterclockwise will
loosen the lock.
Too tight will reduce the slack and make it
harder to engage the lock. Make the
adjustments in 1/4 turn increments and test
the lock until the optimum adjustment is
achieved.
NOTE: When turning the hex screw, do not
exceed half turn increments.
Overtightening will prevent the console
from locking into place and too loose will
make the console loose. You may try 1/2
turn adjustments, but the console may be
too tight or have too much slack.
. 1
EV
Adjusting the XY Locking Mechanism
Steps
Chapter 6 Service Adjustments
LOGIQ E10 B
ASIC
Corresponding Graphic
XY Adjustment for Operator Panel
S M
ERVICE ANUAL
6 - 15