Light Block (Hard Drive/Network Status) Replacement - GE LOGIQ E10 Basic Service Manual

D 5750007-1EN, R
IRECTION
8-11-19

Light Block (Hard Drive/Network Status) replacement

Manpower /
Time
One person /
15 minutes
Table 8-354 Preparations and Preparation Links
Energy Control and Power Lockout for LOGIQ E10:
WARNING WARNING
When servicing parts of the Ultrasound System where there is exposure to voltage greater than 30
Volts:
1. TURN OFF THE SCANNER.
2. UNPLUG THE SYSTEM.
TAG
&
3. MAINTAIN CONTROL OF THE SYSTEM POWER PLUG.
LOCKOUT
4. WAIT FOR AT LEAST 20 SECONDS FOR CAPACITORS TO DISCHARGE AND THE ON/OFF
Signed Date
BUTTON (WHITE LIGHT ON THE OP PANEL) TO TURN OFF, AS THERE ARE NO TEST POINTS
TO VERIFY ISOLATION.
J10
5. REMOVE THE BATTERY COVER AND DISCONNECT THE POWER CABLES J10 and J11 (black
TAG
&
LOCKOUT J11
and red) FROM THE BACKPLANE. See:
Signed Date
J10
replacement" on page
J11
Beware that the Main Power Supply, the Batteries, Power Module, ECB Shear Wave Capacitor Pack
may be energized, even if the power is turned OFF if the cord is still plugged into the AC Outlet.
1. Power down the system.
2. Disconnect the mains power cable from the wall outlet, all Probes and External I/O Cabling.
3. Remove the Side Covers , the Battery Cover , Front Cover and Printer or Printer Filler Storage.
Preparation Links (if you need more information):
•
4-2-4 "Power SHUT DOWN" on page 4-9
• 8-6-3 "Side Cover(s)/Side Air Intake (Filter) inspection / replacement" on page 8-33.
• 8-6-4 "Front Cover replacement" on page 8-38.
8 - 342 Section 8-11 - Front End Acquisition / Card Cage parts replacement
. 1
EV
Table 8-353 Manpower / Time and Tools
Refer to: 8-2-5 "Tools needed for servicing the LOGIQ E10" on page 8-6
8-2-6 "PPE Required During Service" on page
Preparations - you must perform the following steps
8-327.
.
LOGIQ E10 B
Tools / PPE
8-6.
8-2-2 "Warnings" on page 8-3
S M
ASIC ERVICE ANUAL
/
and 8-11-15 "Rear I/O