GE LOGIQ E10 Basic Service Manual page 435

Hide thumbs Also See for LOGIQ E10:

Table of Contents

5750007-1EN, R

Turn the tension adjustment screw (8), so that the

flat side faces the brake shoe (8a), to further release

the lock (brake) motor assembly.

NOTE: When replacing the brake on the right rear

side (A) and the brake on the left front side (B), the

tension adjustment screw (C) turns counter-

When replacing the brake on the right front side (A)

and the brake on the left rear side (B), the tension

adjustment screw (D) turns clockwise.

After the motor assembly is released, loosen the

retaining screw (8b) a little, then gently pry up on the

XY Hinge (8c) with a flat blade screwdriver. Alternate

both steps until the brake can be rocked out

The brake assembly needs to be gently pried out on

both ends, a little at a time, to rock it out of the arm

(Alignment for removal {E}).

Before installing the new lock motor and after the old

motor assembly is removed, place a piece of sticky

tape (circled) on the tension adjustment screw on the

replacement motor. The tape is for holding the screw

in place and keep it from falling, while inserting the

motor into the frogleg arm.

NOTE: Remove the tape after the replacement brake

is secured into the frogleg.

Install a new lock motor assembly by aligning the XY

Hinge (10) into the slot in the brake shoe (10a).

When the lock motor assembly is properly aligned

and inserted, push the assembly in by the XY Hinge

as the retaining screw (10b) is tightened.

NOTE: The lock assembly may have to be rocked in

from side-to-side and end-to-end for proper

Reconnect the wire connectors from the lock motor assembly to the frogleg wiring (refer to Step 7 for

Plug the power cord back into the wall outlet and power up the system.

Chapter 8 Replacement Procedures

Corresponding Graphic

Chapters

Table of Contents