Add A Self-Access Rule; Figure 9.7 Self-Access Acl Configuration Page - Asus iPBX30 User Manual

iPBX30 User Manual
Figure 9.7. Self-Access ACL Configuration Page

9.6.1 Add a Self-Access Rule

To add a Self-Access rule, follow the instructions below:
1. Click Firewall/NAT ->Self-Access ACL menu to open the Self-
Access Rule Configuration page.
2. Select "Add New" from the "ID" drop-down list.
3. Set desired action (Allow or Deny) from the "Action" drop-down list.
4. Assign a priority for this rule by selecting a number from the
"Move to" drop-down list. Note that the number indicates the
priority of the rule with 1 being the highest. Higher priority rules
will be examined prior to the lower priority rules by the firewall.
5. Make desired changes to any or all of the following fields:
source/destination IP, service, time and log.
6. Click on the "Add" button to create the new Self-Access
rule. The new rule will then be displayed in the Existing Self-
Access ACL list table at the bottom half of the Self-Access ACL
configuration page.
Chapter 9
77