Configuring Pppoe Unnumbered For Wan - Asus iPBX30 User Manual

iPBX30 User Manual
Setting
MTU
Disconnect after
Idle (min.)
Connect on
Demand
Status
Manual
Disconnect/
Connect
5.2.3.2 Configuring PPPoE Unnumbered for WAN
Follow the instructions below to configure PPPoE unnumbered
settings:
1. Click the Router Setup -> Connection menu to open the
Network Setup configuration page.
2. Select which WAN port (WAN1/WAN2) to configure for PPPoE
unnumbered connection mode.
3. Select PPPoE Unnumbered from the WAN Connection Mode
drop-down list.
4. Check NAPT box if NAT is to be used for this connection.
5. Enter user name and password provided by your ISP
6. (Optional) Enter the service name and/or AC name if required by
your ISP.
7. Enter the IP address, unnumbered network address, and
unnumbered netmask provided by your ISP.
Description
You may specify the maximum size of the transmitted
packet. For PPPoE, the range of MTU is from 546 to 1492.
The default value is 1454.
Enter the inactivity timeout period at which you want to
disconnect the Internet connection when there is no traffic.
A value of 0 means no activity time out. Note that SNTP
service may interfere with this function if there are activities
from the service.
Click on the Enable or Disable radio button to enable or
disable this option.
On: PPPoE unnumbered connection is active.
Off: No PPPoE unnumbered connection is active.
Connecting: iPBX30 is trying to connect to your ISP using
PPPoE unnumbered connection mode.
Click the Disconnect or Connect button to disconnect or
connect using the PPPoE unnumbered connection mode.
Chapter 5
35