Table of Contents
Advertisement
Chapter 5
Settings
Host Name
IP Address
Subnet Mask
5.1.3 Configuring the LAN IP Address
Follow these steps to change the default LAN IP address.
1. Click the Router Setup -> Connection menu to open the
Connection configuration page.
Figure 5.1 Network Setup Configuration- LAN Configuration
2. (Optional) Enter the host name for iPBX30. Note that the host
name is used for identification purpose only.
3. Enter the LAN IP address and subnet mask for the iPBX30 in
the space provided.
4. Proceed to the WAN Configuration section for instructions on
setting up the WAN port if you have not yet done so.
5. Click "Apply" to save the settings. If you were using an Ethernet
28
Table 5.1 LAN Configuration Parameters
Description
For identification purpose only.
The LAN IP address of the iPBX30. This IP
address is used by your computers to identify
the iPBX30's LAN port. Note that the public IP
address assigned to you by your ISP is not your
LAN IP address. The public IP address identifies
the WAN port on the iPBX30 to the Internet.
The LAN subnet mask identifies which parts of
the LAN IP Address refer to your network as a
whole and which parts refer specifically to nodes
on the network. Your device is preconfigured with
a default subnet mask of 255.255.255.0.
iPBX30 User Manual
Advertisement
Table of Contents
