Table of Contents
Advertisement
Chapter 3
3 Quick Start Guide
This chapter provides basic instructions for connecting the iPBX30
to a computer or a network and to the Internet.
• Part 1 provides instructions to set up the hardware.
• Part 2 describes how to configure Internet properties on your
computer(s).
• Part 3 shows you how to configure basic settings on the iPBX30
to get your LAN connected to the Internet.
This chapter assumes that you have already established ADSL
or cable modem service with your Internet service provider (ISP).
These instructions provide a basic configuration that should be
compatible with your home or small office network setup. Refer to
the subsequent chapters for additional configuration instructions.
3.1 Part 1 — Connecting the Hardware
This section instructs you on how to connect the device to an ADSL
or a cable modem (which in turn is connected to a phone jack or a
cable outlet), the power outlet, and your computer or network.
Follow the steps that follow for specific instructions.
3.1.1 Step 1. Connecting an ADSL or a cable
modem
For the iPBX30: Connect one end of the Ethernet cable to the port
labeled WAN on the rear panel of the device. Connect the other
end to the Ethernet port on the ADSL or cable modem.
12
Note: To verify that your setup is working properly,
refer to "3.3.2 Testing Your Setup".
Warning: Before you begin, power off all devices,
including your computer(s), your LAN hub/ switch (if
applicable), and the iPBX30.
iPBX30 User Manual
Advertisement
Table of Contents
