Table of Contents
Advertisement
Chapter 11
2. Check the SNMP Enable box to enable the SNMP support;
otherwise, uncheck the box.
3. Enter RO (read only) and R/W (read and write) community
names.
4. Enter the IP address of the SNMP management station that
receives trap messages from the iPBX30.
5. Click on Apply button to save the settings.
11.6
Log Setup
Log messages are stored in dynamic memory and will disappear
after system is rebooted. To keep a copy of the log messages,
you can setup a syslog server and have iPBX30 send out the log
messages to the server.
11.6.1 Setting Up Remote Logging Using a Syslog Server
100
Figure 11.5. SNMP Configuration Page
Figure 11.6. Syslog Server Configuration
iPBX30 User Manual
Advertisement
Table of Contents
