Part 2 - Configuring Your Computers; Before You Begin; Table 3.1 Led Indicators - Asus iPBX30 User Manual

Chapter 3
You should verify the status of the LEDs as indicated in the table below.
LED
POWER
LAN LEDs
WAN
3.2 Part 2 — Configuring Your Computers
This section provides instructions for configuring the network settings
on your computers to work with the iPBX30.

3.2.1 Before you begin

By default, the iPBX30 automatically assigns all required network
settings (e.g. IP address, DNS server IP address, default gateway
IP address) to your PCs. You need only to configure your PCs to
accept the network settings provided by the iPBX30.
• If you have connected your PC via Ethernet to the iPBX30,
follow the instructions that correspond to the operating
system installed on your PC.
14

Table 3.1 LED Indicators

Status
Solid green indicating that the device is ON.
If this light is not on, check if the AC adapter is
attached to the iPBX30, and if it is plugged into a
power source.
S o li d gr ee n i nd ica tin g th at the d evice ca n
communicate with your LAN.
Flashing when the device is sending or receiving
data to or from your LAN computer(s).
S o li d gr ee n i nd ica tin g th at the d evice ha s
successfully established a connection with your
ISP.
Flashing when the device is sending or receiving
data to/from the Internet.
Note: In some cases, you may want to configure
network settings manually to some or all of your
computers rather than allow the iPBX30 to do so.
See page 18 for instructions.
iPBX30 User Manual