Table of Contents
Advertisement
iPBX30 User Manual
11.5
SNMP Setup
SNMP (Simple Network Management Protocol) as its name
suggests is used for network management. You may use the SNMP
configuration page to enable or disable the SNMP support.
11.5.1 SNMP Configuration Parameters
The table below describes the configuration parameters available
for SNMP setup.
Table 11.1. SNMP Configuration Parameters
Field
SNMP Enable
R O C o m m u n i t y
Name
R W C o m m u n i t y
Name
Trap Address
11.5.2 Configuring SNMP
1. Click the Management ->SNMP menu to open the SNMP
configuration page.
Description
Check this box to enable the SNMP support; otherwise,
uncheck this box.
Community string is a clear text string that is used as
password between the SNMP management station
and the Internet Security Router. This "Read Only"
community name is used by the SNMP management
station to read the settings in the Internet Security
Router.
Community string is a clear text string that is used
as password between the SNMP management
station and the Internet Security Router. This "Read
and Write" community name is used by the SNMP
management station to read and configure the
settings in the Internet Security Router.
Trap message is sent by the Internet Security Router
to tell the SNMP management station that something
has happened on the Internet Security Router. This
field is used to enter the IP address of the SNMP
management station that is supposed to receive trap
messages from the Internet Security Router.
Chapter 11
99
Advertisement
Table of Contents
