Figure 12.15 Sip Page - Asus iPBX30 User Manual

Chapter 12
3. Check server RTP relay as "No", "NAT:" as "No"
4. Click "Add" to complete this configuration.
5. Follow the instructions above to set up extension "1002".
6. For AX-112 user under NAT device over internet (extension
1003), all settings are the same except that you should check
the "NAT:" field as "Yes".
7. After all setting are completed, click "Utility" item from the left
side menu , and click "Hot reload" to make iPBX30 reload all
the settings and take effective.
Configure the SIP client devices
After you have created these AX-112 accounts, you have to setup
proper parameters for each AX-112 account.
To configure the SIP client devices:
1. Connect AX-112 to iPBX30 using RJ45 cable, connect an
analog phone set to AX-112 using RJ11 cable, and power on
AX-112.
2. Pick up the phone and dial "****" to hear AX-112 IVR (Interactive
Voice Response) menu.
3. Dial "100#" and AX-112 reports you the device status. Listen
carefully for WAN IP reporting and open a browser with this IP.
4. Enter AX-112 GUI and click "SIP" on the above menu. Enter
iPBX30 LAN IP (192.168.1.1 as assumed) in "*IP" field. Enter
132

Figure 12.15 SIP page

iPBX30 User Manual