Table of Contents
Advertisement
Configuring Your Computer
Prior to accessing the router through the LAN port, note the following
necessary configurations—
•
Your PC's TCP/IP address: 192.168.1.__( the last number is any
number between 2 and 254)
•
The router's default IP address: 192.168.1.1
•
Subnet mask: 255.255.255.0
Below are the procedures for configuring your computer. Follow the
instructions for the operating system that you are using.
Windows 2000
1. In the Windows taskbar, click on the Start button and point to
Settings, Control Panel, and Network and Dial-up Connections (in
that order).
2. Click on Local Area Connection. When you have the Local Area
Connection Status window open, click on Properties.
3. Listed in the window are the installed network components. If the
list includes Internet Protocol (TCP/IP), then the protocol has
already been enabled, and you can skip to Step 10.
4. If Internet Protocol (TCP/IP) does not appear as an installed
component, then click on Install.
5. In the Select Network Component Type window, click on protocol
and then the Add button.
6. Select Internet Protocol (TCP/IP) from the list and then click on OK.
7. If prompted to restart your computer with the new settings, click
OK.
8. After your computer restarts, click on the Network and Dial-up
Connections icon again, and right click on the Local Area Connection
icon and then select Properties.
9. In the Local Area Connection Properties dialog box, select Internet
Protocol (TCP/IP) and then click on Properties.
10. In the Internet Protocol (TCP/IP) Properties dialog box, click in the
radio button labeled Use the following IP address and type
192.168.1.x (where x is any number between 2 and 254) and
255.255.255.0 in the IP address field and Subnet Mask field.
Zhone Bonded Channel
User Manual
Version 1.1
Document #: BD-ZU0007-11
10
Advertisement
Table of Contents
