Mirror Position - Fine Correction
The MMS200 motion system allows for the 2 positional modes, Fine Correction Enabled, Fine Correction Disabled. By default Fine Correction is dis-
abled, due to the behavior that the mirror makes a small correction update at the end of travel - this can be seen as an error without fully under-
standing the system. With fine correction disabled, mirror position is consistent with no correction at the end of travel.
Certain installations and uses require different levels of mirror precision, choose the mode that best fits the need.
Correction can be enabled by using editing the Control Trigger Channel
(Channel 6)
1 thru 127
128 thru 255
Note: 04/10/15
This feature is not currently implemented, please see support site for software updates.
**When this feature becomes available, this note will be removed
MMS200 User Guide --- (Details subject to change, and clarification)
Fine Correction off
Fine correction on
53