Table of Contents
Advertisement
MMS200 Menu Options
The sections further explains settings shown in the fixture's menu map.
Address Menu (AddR)
The DMX Start Channel is the first channel of a device's channel range on a DMX link and identifies the fixture for the DMX con-
troller. There are 512 available channels on each DMX universe divided among all the devices in a particular universe. A device
must have a unique DMX Start Channel number in order to respond independently to controller commands. You must assign a
DMX start channel to every fixture on the link.
The Address menu allows you to change the DMX start channel that is currently assigned to the fixture. The fixture's DMX chan-
nel range must not overlap any other device's channel range on the link. When two devices on the same DMX universe have over-
lapping channel ranges, one or both devices will be disabled or behave erratically.
Tip: If two or more fixtures need to respond to controller commands in exactly the same way. In that case, those fixtures must be
the same type and must share the entire channel range.
To set the DMX start channel:
1. Press and hold <Menu> until AddR appears on the LED display. Press <Enter> to select.
2. Select a new DMX start channel. The LED display flashes when a new start channel is selected.
3. Press <Enter> to accept the new DMX start channel. The LED display stops flashing when a new option is entered. If you
do not press <Enter>, the new option you selected is not stored.
Set Menu (SET)
---> Setting Factory Defaults (FACT)
When you set this menu item to ON, all factory options return to their default settings. If no settings have been modified, this
menu will default to OFF. Selecting OFF will result in no change.
The MMS200 factory default options are:
Pan / Tilt Swap = Off
l
Pan / Tilt Invert = Off
l
LED Display = On, Bright
l
To apply factory defaults: setting:
1. Press and hold <Menu> until AddR appears on the LED display.
2. Scroll to the SET menu. Press <Enter> to select.
3. Scroll to the FACT menu press <Enter>.
4. Scroll to ON to restore the factory option defaults.
5. Press <Enter> to store.
MMS200 User Guide --- (Details subject to change, and clarification)
39
Advertisement
Table of Contents
