Renesas RL78/I1A User Manual page 40

RL78/I1A
<4>
Figure 33:
<5>
<6>
Figure 34:
R01UH0363EJ0100 Rev. 1.00
March 23, 2012
Open the "DMX512 Property" dialogue box by selecting the Project menu and
clicking on DMX512... or simply by clicking on the "Setting" button. Check that
the settings are as shown below.
Applilet EZ for HCD Controller DMX512 Property Dialogue Box
Make sure that SW2 dip switch of the RL78/I1A DC/DC LED Control Evaluation
Board is in flash programming mode, and that the USB and power supply cables
are connected correctly. Click the "Save" button and then the "All P." button.
After downloading the application, please disconnect the USB and power supply
cables and set the board to the normal operation mode.
You should now be able to control the LEDs on the RL78/I1A DC/DC LED
Control Evaluation Board via the DMX512 protocol by connecting a DMX512
master device. For example, Renesas Electronics offers the Lighting
Communication Master Evaluation Board (EZ-0008). This board can be used as
a communication master device supporting DMX512, DALI and IR
communications.
The RL78/I1A DC/DC LED Control Evaluation Board can be controlled by this
Lighting Communication Master Evaluation Board together with a GUI running on
the host PC. There is a GUI for DMX512 control and a GUI for DALI control, both
GUIs can be downloaded from the Renesas Electronics website.
System Configuration for DMX512 Control
Chapter 8 Applilet EZ for HCD Controller
31