Chapter 7 How To Use Writeez5 Flash Programming Software - Renesas RL78/I1A User Manual

RL78/I1A
Chapter 7 How to Use WriteEZ5 Flash Programming
Hardware
Configuration of
RL78/I1A DC/DC
LED Control
Evaluation Board
Software
Configuration of
WriteEZ5 GUI
<1> Installing the
WriteEZ5 GUI
<2> Installing the
driver
<3> Installing the
parameter files
<4> Setting and
connecting
Table 11:
R01UH0363EJ0100 Rev. 1.00
March 23, 2012

Chapter 7 How to Use WriteEZ5 Flash Programming Software

Software
This chapter explains the basic operations of the WriteEZ5 GUI for programming
the RL78/I1A DC/DC LED Control Evaluation Board. This chapter covers how to
start the system, execute the EPV command (Erase, Program, Verify), and
program the target RL78/I1A device.
The conditions of the series of operations described in this chapter are as
follows:
Board:
CPU:
Target Device:
Voltage level:
Parameter file:
Clock setting:
Port:
Operation mode:
Write HEX file:
Option Setting:
Running the Software CD installation supplied with this product will automatically
deploy the correct software.
Running the Software CD installation supplied with this product will automatically
deploy the correct software.
Running the Software CD installation supplied with this product will automatically
deploy the correct software.
Set the RL78/I1A DC/DC LED Control Evaluation Board by configuring switch
SW2 as following:
Bits
1
2
3
4
5
6
7
8
SW2, Configuration for Flash Programming Mode
RL78/I1A DC/DC LED Control Evaluation Board
RL78/I1A
R5F107DE
5 V
R5F107DE.pr5
Internal-OSC
COMxx (115200bps)
Chip
*.hex
Blank check before Erase
Configuration
OFF
OFF
ON
OFF
ON
OFF
ON
OFF
15