Renesas RL78/I1A User Manual page 35

RL78/I1A
<6>
Figure 24:
<7>
Figure 25:
<8>
R01UH0363EJ0100 Rev. 1.00
March 23, 2012
Next click OK when prompt to start flash programming.
Applilet EZ for HCD Controller Start Flash Programming
During the flash programming procedure you will be informed about the actual
status of the programming.
Applilet EZ for HCD Controller Flash Programming Status
Click CLOSE to exit the "Build" window. Remove the USB cable and the power
supply cable, and change the SW2 dip switch positions to the normal operation
mode. Plug the power supply cable to the board connector again and you should
see the LEDs light up according to the duty values set earlier.
LED channel 1 = Red
LED channel 2 = Green
LED channel 3 = Blue
Chapter 8 Applilet EZ for HCD Controller
26