Ir Remote Control Dimmer Program - Renesas RL78/I1A User Manual

RL78/I1A
<7>
<8>
<9>
<10>
<11>
Note

8.7 IR Remote Control Dimmer Program

<1>
<2>
<3>
Figure 38:
R01UH0363EJ0100 Rev. 1.00
March 23, 2012
On the Lighting Communication Master Evaluation Board, please confirm that
SW4 is set to "RUN".
Connect the Lighting Communication Master Evaluation Board (EZ-0008), via the
DALI connector J4, with the RL78/I1A DC/DC LED Control Evaluation Board
(acting as a DALI slave board), via the DALI connector CN2, using the two wires
provided.
Connect the Lighting Communication Master Evaluation Board to the host PC
using a USB cable.
Plug the DC 5V power supply cable to the RL78/I1A DC/DC LED Control
Evaluation Board via connector CN1.
Send DALI commands to the RL78/I1A DC/DC LED Control Evaluation Board
using the DALI Master Controller GUI.
To find details about the DALI Master Controller GUI, please refer to the
corresponding User's Manual (U19607EJ1V1UM00) that can be downloaded
from the Renesas Electronics website.
This sample shows how to set up Applilet EZ to program the IR remote control
dimming program into the R5F107DEG assembled to the RL78/I1A DC/DC LED
Control Evaluation Board.
Make sure that you have set all the settings as explained in the 8.1 General
Settings section.
Save the new Applilet EZ project (.hcd file). Select the File menu, then click on
Save As... or simply click on the "Save" button, and input "ir.hcd" for example.
To finish click Save.
We now have a new Applilet EZ project file and we will change the dimmer
program to IR Remote Control. The "Custom Code" and "Data Code" can be
customized according to the user's needs.
Applilet EZ for HCD Controller Dimmer Program Selection (IR)
Chapter 8 Applilet EZ for HCD Controller
34