2
Setting up the M5302A module
2.2.3: Installing the Embedded Controller
CAUTION
36
Before installing the module, remove plastic thread protectors on the top
and bottom of mounting screws. Use the appropriate instructions below
for installing the embedded controller or the remote controller.
Do not power up the controller until instructed to do so later in this
document.
Figure 8
Front panel view of M9037A Embedded Controller
If your configuration contains a Keysight Embedded Controller (for
example, M9037A), follow the procedure below. For additional details,
refer to the instructions in
1
Remove the M9037A module from its ESD protective bag. See
"Precautions against
2
Install the embedded controller in Slot 1 (see the
slot) in the chassis.
the M9037A Startup
Guide.
ESD" on page 30.
M5302A PXIe LVDS Digital IO Modules Startup Guide
icon above the