34946A and 34947A Dual/Triple Microwave Switch Modules
Installing Switches Externally to the Module
The steps for installing the cable assembly and 9-pin D-Sub connectors are as
follows:
1 Remove the 34946A or 34947A cover by removing the screw (T-10 torx) on
34946A w/Option 001
9-pin strand
Figure 1
2 34946A - Route the center and left 9-pin strands through the corresponding
Keysight 34946A-34947A Microwave Switch/Driver Modules User's Guide
the top of the instrument (Figure 1).
align connector contacts over rows in cable strand
34946A and 34947A Option 001 Installation
Be careful when handling the 34946A or 34947A chassis with the
cover removed as components within the chassis are susceptible
to damage from ESD.
slots of the instrument face plate (Figure 1). Cut the cable strands to the
desired length, or if necessary, the full length of the strands can be used.
34947A w/Option 001
9-pin strand
13