Keysight Technologies M5302A Startup Manual page 46

2 Setting up the M5302A module
46
Figure 17 Verifying change of signal state on Oscilloscope
If you do not see the signal state toggling, try one of the following steps:
• Check connection between module and Oscilloscope.
• Connect another port on the M5302A module to the same or another
Channel on the Oscilloscope.
• Remove and reinstall the M5302x software.
For further support, contact a technical support executive at Keysight. Visit
https://www.keysight.com/find/support.
M5302A PXIe LVDS Digital IO Modules Startup Guide