3.5.6
User-Defined Programs (U)
Each user has one user-defined program with eight segments available to set.
1.
Choose the user-defined program (U) and confirm your choice with the Mode button.
2.
Set the resistance level for each segment with the encoder and confirm each segment with the
Mode button (Fig. 16).
NOTICE
L
To cancel the program while setting, press and hold the Mode button for two seconds.
3.
Set the time with the encoder and confirm the value with the Mode button.
4.
To start the program, press the START/STOP button.
NOTICE
L
The resistance level can be changed with the encoder during training.
At the end of the program a signal will be heard.
5.
To pause the program, press the START/STOP button again.
6.
To end the program, press the RESET button.
The display will change to the main menu.
Figure 16
29