Figure 8
3.5.3
Pre-Set Profile Programs
There are a total of 12 pre-set programs available to choose from.
1.
Choose one of the pre-set programs and confirm your choice with the Mode button.
2.
Set a resistance level with the encoder and confirm with the Moder button.
NOTICE
L
The standard value is 1 (Fig. 10).
3.
Set the time with the encoder and confirm the value with the Mode button.
4.
To start the program, press the START/STOP button.
NOTICE
L
The resistance level can be changed with the encoder during training.
At the end of the program a signal will be heard.
5.
To pause the program, press the START/STOP button again.
6.
To end the program, press the RESET button.
The display will change to the main menu.
Figure 10
26
Figure 9
BX30 Plus