Equipment And Tools Necessary For Installation - Konica Minolta REGIUS 110 HQ Installation Manual

1.1.8 Equipment and Tools Necessary for Installation

Before installing, prepare the following equipment and tools.
Name
Installation Completion
Check Sheet/Report
Cutter
Cutter with a guide
Phillips head screwdriver
Soft cloth
Ethernet cable
Network hub
Maintenance PC
CD containing the new
version of the REGIUS
console program
Used to check the installation of the unit and receive sign-off on installation
completion.
Used for unpacking.
Used to open moisture-proof bags (during unpacking).
Name of the recommended product: Opener
Manufacturer: OLFA
Product number: 30B
Used to remove protective parts.
Used to clean the machine (external).
Used to temporarily connect a REGIUS console to the unit for setting up the
network. Use a category 5e or higher cable.
A cross cable can be used instead.
Interface specifications: RJ-45 connector
100 Base-TX/1000 Base-T
Used when setting up the network for the unit without using an existing
REGIUS console in the system.
Since it is used instead of a REGIUS console, the REGIUS console
application must be installed in the PC.
The application program must be upgraded when the current REGIUS
console application does not support the unit to be connected to the
existing REGIUS console.
The following versions of the REGIUS console application support the unit.
•
CS-3: Version 3.01 R00 and later
•
CS-2: Version 1.40 R00 and later
1-5
1.1 Preparations for Installation
Remarks