Table of Contents
Advertisement
Preparations
Setting up FD-9
❙ ❙
The FD-9 should be set up on a flat, level surface with sufficient space for the color chart in front of and behind the FD-9. There should be
enough space in front of the FD-9 for the color chart to be measured to be inserted into and ejected from the FD-9 without any obstacles,
and enough space behind the FD-9 for the color chart to fully extend from the FD-9 without obstacles. (See below.)
• If the FD-9 is set up on a rough surface or a surface which is not level, measurement accuracy may suffer.
• Obstacles may cause the color chart to bend or be shifted to either side, resulting in damage to the color chart or misalignment during
scanning.
• After scanning, the scanned color chart will be ejected from the front of the FD-9. If the FD-9 is placed at the edge of a table, the
ejected color chart might fall to the floor and be damaged.
Necessary space
12
Advertisement
Table of Contents
