2.2
Unpacking
This section describes the packaging format of the product and the procedure for unpacking the product
after its arrival.
•
The unit weighs approximately 102kg. Secure sufficient space to transport and move it, and
work carefully.
Caution
•
Place a palette in a level location before starting unpacking. If unpacking is carried out on a
sloping surface, the machine may move.
•
Unpack the product in an area with sufficient space.
When the product is unpacked in a place other than the installation location, check that there
Important
are no steps or obstacles in the way to the installation location.
For information about the unpacking space, refer to
•
If the machine is unpacked immediately after it is moved in, dew condensation may form
inside the machine due to indoor/outdoor temperature differences (approximately 10°C or
more). To prevent this, let the product stand for approximately one hour at the installation
location before unpacking.
Requirements
The procedures described in this manual require the following tools:
No.
1
Cutter
It is recommended that a cutter with a guide be used to avoid damaging
the main unit when opening the moisture-proof bag.
Note
Name of the recommended product: Opener
Manufacturer: OLFA
Product number: 30B
Tools
No.
2
2-3
"1.1.5 Checking Unpacking
Tools
Cutter with a guide
2.2 Unpacking
Area".