Computer Control Of The Force Gauge; Rs232 Output Signal - sauter FL Instruction Manual

9 Computer control of the force gauge

With the RS 232 interface a connection from the force gauge to the PC can be
established by sending RS232 commands.
RS232 command
"„m"
"„u"
"„z"
"„r"

10 RS232 output signal

The reading of the FL shown on the display can be transferred to the PC by pressing
the PRINT button or by issuing a command instruction to the force gauge from the
PC.
RS232
command
""l"
""p"
""c"
- Send the direct reading with unit if the current mode is
"x" or
pressing - Send peak value (on pull) with unit if the current mode
PRINT KEY
- Send peak value (on pressure) with unit if the current
""d"
""!"
capacity, serial number, firmware check, original offset,
FL-BA-e-2020
Action
Change measuring mode
Change measuring unit
Set device to "zero
Perform reset on the device
Send the direct reading with unit
Send peak value (on pull) with unit
Send peak value (on pressure) with unit
the track mode
is peak mode
mode is the peak value print mode
Send information about the device such as model,
current offset, overload counter
Action
Send save
13