Table of Contents
Advertisement
4. Description of the control panel
4-7
4-10
4-9
4-2
here: Model TE-1250-0.1FN
4-8
4-4
4-3
4-1
4-5
4-6
4- 1 Measuring probe
4- 2 Display
4- 3 Zero key
4- 4 Plus button
4- 5 Minus key
4- 6 On/off button (multifunctional)
4- 7 µm/ mil Changeover key (shortcut key)
4- 8 Battery compartment / rear cover
4- 9 Connector for RS-232C connection
4-10 S/C measuring mode button (single/continuous)
5. Measuring procedure
5.1 Connect F or N measuring probe - depending on the measured object
5.2 Switching on with the on/off button 4-6. '0' appears on the display 4-2.
The meter can recognize the probe itself by the symbol of the probe "Fe" (= F) for
ferrous metals or "NFe" (= N) for non-ferrous metals shown on the display.
5.3 Placing the measuring probe 4-1 on the layer to be measured. The layer thickness
can now be read on the display. The reading result can be corrected by pushing the
plus key 4-4 or the minus key 4-5. For this purpose the probe should not be placed in
close proximity to the layer to be measured or the zero plate.
TE-BA-e-2020
5
Advertisement
Table of Contents
