Table of Contents
Advertisement
4. Description of the control panel
Model TC-F and TC-N
4-7
4-10
4-9
4-4
4-1 Measuring
probe: F, N, or FN
4-2
Display
4-3
Zero key
4-4
Plus button
4-5
Minus key
4-6
On and Off button (multifunctional)
4-7
µm/ mil Changeover key (shortcut key)
4-8
Battery compartment / cover
4-9
S/C measuring mode button (single/continuous)
4-10
Connector for RS-232C connection
4-11
F/ NF- key
5. Measuring procedure
a) Switch on by pressing the on/off button 4-6. '0' appears on the display 4-2.
The TC 1250-0.1FN meter recognizes the setting of the last measurement itself by the
symbol 'Fe' (= F) for ferrous metals or 'NFe' (= N) for non-ferrous metals shown on the
display. It switches to the automatic measuring mode, which also correctly recognizes
and assigns the zero plate or any other substrate itself.
b) Place the measuring probe 4-1 on the layer to be measured. The layer
can now be read on the display. The reading result can be corrected by pressing the
plus key 4-4 or the minus key 4-5. For this purpose, the measuring probe should not
be in close proximity to the layer to be measured or the zero plate.
c) To take the next measurement, simply raise the measuring probe 4-1 by more than
1cm, the display will show "0" again and step b) will be repeated.
TC-BA-e-2020
4-2
4-11
4-8
4-10
4-6
4-5
4-4
4-3
4-1
Model TC-FN (Combi Model)
4-2
4-7
4-8
4-5
thickness
5
Advertisement
Table of Contents
