Functions; Limit Value Display Good / Bad; Invert Display; Store Measured Value In Memory - sauter FL Instruction Manual

8 Functions

8.1 Limit value display Good / Bad

LED display for good / bad tests
Colour Function
Red Exceeding the upper limit value
Indicates that the pass-fail criterion has been
Green
reached
Yellow Falling below the lower limit value
An upper and a lower limit value can be programmed. The measuring instrument
compares the measurement result with the limit values and outputs the result as a
signal in red or green light diodes.
Setting of the limit values see MENU →PASS-FAIL
With the left arrow key the cursor is moved to the desired value. With the UP or
DOWN key the value can be changed. By pressing and holding one of these keys,
scrolling is possible. With the right arrow key the unit can be changed. With the
ENTER-key the settings are saved and you return to the main menu.
The display now shows a "PF".
The PASS-FAIL option is automatically disabled if the upper and lower limits are set
to 0 Newton. The lower value must also always be smaller than the upper one.

8.2 Invert display

The display can be rotated by 180°. To do this, do the following:
When the power is off, press and hold the "MENU/ESC" key. In addition, the "On/Off"
key is pressed and the unit switches on, thus rotating the display.

8.3 Store measured value in memory

Any measured value can be stored in the memory at any time by pressing the
ENTER key. A maximum of 500 readings can be stored.
10 FL-BA-e-2020