Table of Contents
Advertisement
• Pairing indicator: shows the pairing status;
o This symbol must appear during measurements. If this is not the case, it
is not possible to measure.
• Operating display: shows whether the unit is switched on.
• FIL:
Group number
• PRB:
Probe active
• VEL:
Sound velocity change
• CAL:
Calibration of the speed of sound
• DPC:
Two point calibration status
• ZER:
Zero calibration of the measuring probe
• SCA:
Shows status scan mode (On/Off)
• Group name: number of the current group
• Measured value: Number: shows the consecutive number.
• Measuring probe models: the selected measuring probe is displayed.
o ATU-US01: N02
o ATB-US06: N05
o ATU-US02: N07
o ATB-US02: HT5
• Sound velocity: shows the current sound velocity.
• Measured value: The display shows the measured value. ↑ means that the upper
measurement limit has been reached. ↓ means that the lower measurement limit
has been reached.
• Unit display: When the mm symbol lights up, the material thickness is measured
in mm and the speed of sound in m/s. When the inch symbol appears, the material
thickness is measured in inches and the speed of sound in inches/s.
3. Description of the control panel
Turning the machine on
and off
Switching
background light on and
off
US measurement probe
Zero setting
Switching
entries
Save data
or delete data
TU_US-BA-e-2020
Exit
the run-
the selection
the
Enter-
Key
scroll forward
between
roll back
7
Advertisement
Table of Contents
