Pcb Removal/Replacement - Prince Castle DCFT-MCD Series Service Manual

Unplug the unit.
1
Failure to disconnect power
from the unit before servicing
could result in severe bodily
injury or death. The ON/OFF
Switch does not disconnect
incoming power to the unit.
Use a Philips screw driver to remove (5) screws
2
holding electronics tray.
Pull out electronics tray.
3
Remove all (9) connections on the PCB
4
Use needle nose pliers to remove PCB from (4)
5
outside plastic stands.
527-504revF_EN

PCB Removal/Replacement

WARNING
Push new board evenly on to 4 outside plastic stands.
6
Reconnect all (9) connections.
7
Plug in Unit
8
Proceed with caution after plugging in unit.
RISK OF ELECTRICAL SHOCK
Use small flathead screwdriver to adjust display with
9
display adjuster until lettering is clear on overlay
display.
Unplug the unit.
10
Push in the electronics tray.
11
Use Philips screwdriver to install electronics tray with
12
(5) screws.
Plug in the unit.
13
33
Vertical Toaster
DCFT-MCD Series
WARNING
Printed in USA 1/15 © 2015