Release Sheet Replacement Instructions - Prince Castle DCFT-MCD Series Service Manual

Vertical Toaster
DCFT-MCD Series
The release sheet should be replaced every 3 months or if
sheet is worn, torn, excessively curled or if there is exces-
sive buildup on sheet.
Excessive buildup, sheet
should be replaced.
Excessively curled sheet
should be replaced.
New release sheet.
Put on a pair of high temperature gloves.
To replace release sheet, remove old sheet.
Printed in USA 10/18 © 2018

Release Sheet Replacement Instructions

Fold and crease release sheet. Fold release sheet in
half and create a crease in the center of the sheet.
Install new release sheet. Be sure that sheet
is centered over platen and the crease in sheet
is centered.
Insert the release sheet over the center bar of the
in-feed chute with one end of the sheet in the
Crown slot and one end in the Heel slot. Position
the crease on the release sheet on top of the in-feed
chute center bar. Be sure that the sheet corners are
not curled, exposing the platen. Check to see that
12.7 mm (1/2") of release sheet extends below each
side of the platen. If 12.7 mm (1/2") of the release
sheet does not extend below the bottom of the platen,
then the sheet is not properly positioned.
12 527-500revJ_EN