Vertical Toaster
DCFT-MCD Series
Remove/Replace Motor and Drive Train Assembly
Unplug the unit.
1
Failure to disconnect power
from the unit before servicing
could result in severe bodily
injury or death. The ON/OFF
Switch does not disconnect
incoming power to the unit.
Remove screws (7) that secure right side panel to
2
frame. Set screws aside.
Using the compression knob removal tool, Remove
3
compression knobs from right side panel.
Remove right side panel from unit.
4
Disconnect electrical connectors (2) from right side
5
panel. Set panel aside.
Printed in USA 1/15 © 2015
WARNING
On both left and right side of conveyor belt, secure
6
vice grip to bracket and top nut to hold assembly in
position.
Repeat step 6 with reverse side.
7
Remove 3/8" nuts (4) that secure drive train cover and
8
drive train to frame. Disconnect electrical connectors
from drive train/motor. Set nuts, cover, and drive train/
motor aside.
Grasp drivetrain firmly, and pull straight back to
9
remove.
24
527-504revF_EN