Remove/Replace Crown Compression Adjust Assy - Prince Castle DCFT-MCD Series Service Manual

Remove/Replace Crown Compression Adjust Assy

Unplug the Unit.
1
Failure to disconnect power
from the unit before servicing
could result in severe bodily
injury or death. The ON/OFF
Switch does not disconnect
incoming power to the unit.
Open and remove back door.
2
Remove screw and
3
nut that secure rear
gear cover to
intermediate support.
Set cover, nut, and
screw aside.
Loosen thumbscrew on left side panel. Set panel
4
aside.
Partially remove club assembly. Refer to Page 27,
5
step 15-17.
Remove retaining ring from shaft. Set ring aside.
6
Retaining
Ring
Remove compression knobs from right side panel.
7
527-504revF_EN
WARNING
Nut
Cover
Screw
Remove screws (7) that secure right side panel to
8
frame. Set screws aside.
Disconnect electrical connectors (2) from panel. Set
9
panel aside.
Remove nuts (4) that secure drive train cover and drive
10
train to frame. Disconnect electrical connectors from
drive train. Set nuts, cover, and drive train aside.
Drive Train
Cover Nuts
Cut cable ties along bottom half of bundled wires
11
coming from crown heater.
Cable Ties
19
Vertical Toaster
DCFT-MCD Series
Printed in USA 1/15 © 2015