Prince Castle DCFT-MCD Series Service Manual page 21

Remove/Replace Crown Compression Adjust Assy (cont.)
Feed camshaft through square opening in frame.
22
Use leverage to secure left and right sides of conveyor
23
into frame.
On both left and right side of conveyor belt, secure
24
vice grip to bracket and top nut to hold assembly in
position.
Bracket
Nut
Install Sprocket shaft and feed through intermediate
25
support bearing.
527-504revF_EN
Attach (2) E-Clips to sprocket shaft both front and
26
back.
Install 6 screws with stubby Philips screw driver.
27
Screws
(3 on each
side)
Reference Club Transfer gear belt install. Page 30.
28
Route crown heater wire through hole in frame.
29
21
Vertical Toaster
DCFT-MCD Series
Printed in USA 1/15 © 2015