Remove/Replace Heel Compression Adjust Assy - Prince Castle DCFT-MCD Series Service Manual

Remove/Replace Heel Compression Adjust Assy

Unplug the unit.
1
Failure to disconnect power
from the unit before servicing
could result in severe bodily
injury or death. The ON/OFF
Switch does not disconnect
incoming power to the unit.
Open and remove front door. Set door aside.
2
Remove screw and
3
nut that secure front
lower gear cover to
immediate support.
Set cover, nut, and
screw aside.
Remove retaining ring from shaft. Set ring aside.
4
Gear
Retaining
Ring
Remove belt from pulley and let hang in place.
5
Slide gear off shaft and set aside.
6
527-504revF_EN
WARNING
Nut
Cover
Screw
Gear Belt
Remove second
7 retaining ring
from drive shaft.
Set ring aside.
Remove compression knobs from right side panel.
8
Remove screws (7) that secure right side panel to
9
frame. Set screws aside.
Disconnect electrical connectors (2) from panel. Set
10
panel aside.
Remove nuts (4) that secure drive train cover and drive
11
train to frame. Disconnect electrical connectors from
drive train/motor. Set nuts, cover, and drive train/motor
aside.
Remove screws (3 on left, 3 on right) that secure heel
12
compression assembly to frame. Set screws aside.
Screws
(3 on each
side)
Drive
Shaft
15
Vertical Toaster
DCFT-MCD Series
Retaining
Ring
Printed in USA 1/15 © 2015