Prince Castle DCFT-MCD Series Service Manual page 28

Vertical Toaster
DCFT-MCD Series
Slide in club assembly partially.
22
Use flat head screwdriver to open clip and put excess
23
high limit switch wire underneath
Install high limit switch into club platen. (Apply AOS
24
Silicone paste if necessary)
Close clip over excess wire.
25
Connect temp probe wires (Red/White female to White
26
male) and (Purple Female to Red/White Male)
Use high temp zip tie to secure high limit switch and
27
club harness (Zip-tie that was removed).
Printed in USA 1/15 © 2015
Remove/Replace Club Assy (Cont..)
Tuck excess wire slack so it does not get pinched
28
when installing club.
Put belt on club transfer gear.
29
Align club shafts with bearing holes.
30
Wrap belt over shaft drive gear.
31
Push down club assy into unit evenly.
32
Use 11/32" nut driver to attach (4) main club assy nuts.
33
Hook cover sheet over terminal block.
34
use 11/32" nut driver to install back terminal cover top
35
nut.
Use flathead screw driver to install bottom back cover
36
screw.
28 527-504revF_EN