Table of Contents
Advertisement
Installing the LOM card and rear I/O board
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the system
board.
NOTE:
The procedure to install the liquid cooling rear I/O board and rear I/O board is the same.
Steps
1. Align the connectors and slots on the LOM card or rear I/O board with the connector and standoffs on the system board.
2. Press the LOM card or rear I/O board until firmly seated on the system board connector.
3. Using a Phillips #2 screwdriver, secure the LOM card or rear I/O board to the system board with screws.
Figure 169. Installing the LOM card and rear I/O board
Safety
instructions.
Before working inside your
system.
Installing and removing system components
183
Advertisement
Table of Contents
