Micromeritics ACCUPYC II 1345 Series Installation Instructions And Checklist page 42

2 Equipment Installation
S D , T
ET ATE IME
1. On the keypad, press Alt + 2 to enter Setup mode.
2. Press Choice until Date displays, then press Enter and enter the current date.
3. Press Choice until Time displays, then press Enter and enter the current time.
4. Press Choice until Language displays, then press Enter and select the correct language.
S R
ETUP EPORTS
The Report Options command enables the report mode (density or volume for analysis) and
specification of the report destination. After analysis or calibration, the display returns to the Reload
prompt. An asterisk (*) in the third line of the display indicates an error message exists.
A report is generated automatically to the destination selected at the Setup > Report Options as
follows:
Printer. Report is automatically sent to the printer.
n
Transmission line. Report is automatically sent through the serial line to an attached device for
n
this purpose.
E-mail. Report is e-mailed to the address specified (when connected to a network).
n
Field or Button
Setup Type?
Report Options
Report Options
Anls Display Mode?
Density
2 - 20
, L
AND ANGUAGE
Description
Press CHOICE until Report Options is displayed.
Press CHOICE to select Density, Volume or Specific Gravity, the
mode in which the analysis report will be displayed. When Density is
selected, a Sample Mass? prompt displays during the Analysis
function. Enter a value for the sample mass. For accurate data, the
sample mass must be entered when choosing Density.
AccuPyc II 1345 Installation Instructions and Checklist
134-42875-02 (Rev A) — Jan 2021