Software Installation - Micromeritics ACCUPYC II 1345 Series Installation Instructions And Checklist

Gas displacement pycnometer

Hide thumbs Also See for ACCUPYC II 1345 Series:

Table of Contents

3 S

OFTWARE

If installing in a CFR21 environment, follow the software installation instructions in the

Confirm Administrator Guide [part number 004-42821-01].

The following prerequisites must be completed prior to installing the software:

Ensure the computer requirements have been met. See

page 1 -

Configure an Ethernet port on the computer to communicate with the analyzer. The IP address

must be 192.168.77.100. Refer to the computer operator manual for instructions on changing the

IP address.

1. Insert the installation media into the media drive. The program automatically starts the install-

ation. If the installation does not immediately start, navigate to the media drive, then locate and

double click the setup.exe file.

2. Click

on the Welcome window.

3. On the Ethernet Introduction window, verify that all prerequisites have been met.

a. If not, click

proceed with installation until these tasks have been completed.

b. If the prerequisites have been met, click Next.

AccuPyc II 1345 Installation Instructions and Checklist

134-42875-02 (Rev A) — Jan 2021

NSTALLATION

Cancel

and complete the steps, then restart the installation program. Do not

3 Software Installation

Specifications for AccuPyc II on

3 - 1

Table of Contents

Do you have a question about the ACCUPYC II 1345 Series and is the answer not in the manual?