Micromeritics ACCUPYC II 1345 Series Installation Instructions And Checklist page 38

2 Equipment Installation
C
OMMUNICATIONS
Communications enables specification of communications criteria, such as baud rate, parity, etc.
Display Text
Setup Type?
Communications
Communications
IP Address?
[choice]
Communications
Requesting Address *
[ENTER] to continue
2 - 16
Description
Press CHOICE until Communications is displayed.
Enables selection of the manner in which the IP address is assigned.
With an IP address, analysis results can be access via a web browser.
Typically, after an analysis (or calibration) is started, results from the
previous operation cannot be reviewed. However, results from five
analyses are stored in the controller. A web browser enables review of
these results. An IP address must exist for this operation. An IP
address can be detected and assigned automatically, or one can be
specified.
Ensure the Ethernet cable is plugged into the Ethernet port on the
analyzer and to the network. Choose DHCP to have an IP address
assigned automatically, or Specify to specify an address. Press
CHOICE until the option is displayed.
If using DHCP, an IP Address should be assigned within a minute.
Displays the first-time selection of DHCP.
Press ENTER. The system automatically attempts to assign an IP
address. If the system is able to determine an address, the assigned
address is displayed.
AccuPyc II 1345 Installation Instructions and Checklist
134-42875-02 (Rev A) — Jan 2021