Micromeritics ACCUPYC II 1345 Series Installation Instructions And Checklist page 41

U T
NIT YPES
These keypad prompts enable selection or entry of:
units of measurement
n
operating language
n
current date and time
n
Display Text
Set-up Type?
Unit Types
Unit Types
Pressure units?
Unit Types
Language?
Unit Types
Date (DD/MM/YY)?
Unit Types
Time (HH:MM:SS)?
AccuPyc II 1345 Installation Instructions and Checklist
134-42875-02 (Rev A) — Jan 2021
Description
Press CHOICE until Unit Types is displayed, then press ENTER.
Enables selection of unit type for reports. Press CHOICE to select the
desired unit.
Options are:
psig (pounds per square inch gauge)
n
kPag (kilopascal gauge)
n
Enables selection of operating language. Pressing SAVE is not
required.
Error messages that may be in the message queue will remain in
English (or the current selected language). Error messages that occur
after selecting the language will display in that language.
Keypad overlays containing translations for the alternate functions are
available for each language. Choose the language.
The date is entered in a two digit format for the day, month, and year.
For example; to set the date for September 1, 2014, enter 01/09/14
(day/month/year). Use the . (decimal) key to enter a slash (/).
The time (in 24 hour format) at which an analysis begins and ends is
shown on all reports. The time shown on the display may not match the
current time.
The time is entered in a two digit format for the hour, minutes, and
seconds. For example; to set the time to 1:05 pm, enter 13:05:00
(hour:minutes:seconds). Use the . (decimal) key to enter a colon (:).
Configure the Pycnometer using the Keypad
2 - 19