Micromeritics ACCUPYC II 1345 Series Installation Instructions And Checklist page 25

Gas displacement pycnometer

Hide thumbs Also See for ACCUPYC II 1345 Series:

Table of Contents

3. Connect separate power cable(s) to external power supply(s).

4. Connect external power supply(s) to power outlet on the module(s).

5. Connect power cable to wall outlet.

6. Toggle the module power switch to the ON position.

7. Check the power indicator on the front panel of the analyzer. The indicator light will blink green

to indicate that power is applied to the analyzer. Once the application is running, the indicator

will stop blinking and remain illuminated.

8. On the keypad, press Alt + CHOICE + 2. Unit [n] appears in the upper left corner of the dis-

play.

9. Adjust the display brightness control using the Brightness Control button on the rear of the

analyzer.

AccuPyc II 1345 Installation Instructions and Checklist

134-42875-02 (Rev A) — Jan 2021

Set Up Procedure

2 - 3

Table of Contents

Need help?

Do you have a question about the ACCUPYC II 1345 Series and is the answer not in the manual?