System Telephone Set Star Code Commands; System Star Code Commands - NEC DT820 Series User Manual

Table A.2
Action
Automatic Ring Back *66 initiate ARB
on Idle
+ Extension
*68 turn of ARB
Blind Transfer FLASH
+ *96
+ extension
Call detail information *75
sent to call detail
+ Password (client-
record
assigned account code)
+#
Call Forwarding *73
Deactivation
DT820 Phone User Guide
When prompted, enter your extension, followed by the
2
When prompted, enter your password, followed by the
3
3 C S Y S T E M T E L E P H O N E S E T S T A R C O D E
C O M M A N D S
You can use several star code commands directly from a telephone set on a 3C
system. Use the following star code commands to set features and perform functions
from any telephone.
Not all star codes may be enabled for your system or your model of phone.
Note:

System Star Code Commands

Analog
Star Code
*66 initiate ARB
+ Extension
*68 turn of ARB
Hold
+ *96
+ extension
+ dial
*75
+ Password (client-
assigned account code)
+*
*73
SIP Star Code
• *66 to set an ARB "notify on idle" for a target
*66 to ARB the last number dialed needs no + Ext.
*66 [ [precedence-digits|] <address> ] = MLPP
• *68 to disable an ARB "notify on idle" for a target
Completes a blind transfer to another extension.
Note: A confirmation tone will sound after applying
this star code command.
Note: When initiating a blind transfer, the star code to
block a caller ID (*67) cannot be part of the specified
blind transfer address. Such an attempt results in a
failed blind transfer. This is the case for blind
transfers via star code (i.e. *96*671000) or blind
transfers via a SIP station where the blind transfer
target address starts with *67.
The phone system sends call detail information to
the call detail record.
Note: Codes are custom assigned by the 3C system
administrator.
Clears the telephone unit's call forwarding
conditions. Once this star code is invoked, you must
add any appropriate forwarding conditions back to
the extension. Any existing forwarding conditions
that were set by the phone application will still remain
in effect.
Note: A confirmation tone will sound after applying
this star code command.
User centric users cannot use this star code. Contact
your system administrator for information on call
forwarding setup for user centric users.
Note:
3 C S Y S T E M F E AT U R E S
#
key.
#
key.
Explanation
A -185