Networkservices Smtp From; Networkservices Smtp Mode; Networkservices Smtp Password; Networkservices Smtp Port - Cisco Webex DX70 Administrator's Manual

Cisco Webex DX70 and DX80

Introduction

NetworkServices SMTP Mode

If your device is registered to the Webex cloud service, you can set up the device to use
SMTP (Simple Mail Transfer Protocol) for sending email from the device to a mail server
for relaying. This is required if you want to allow users to send their whiteboards and
presentations via email to people inside or outside their organization.
If the device is set up for encrypted communication (see the NetworkServices SMTP
Security setting), the device only allows connections where the SMTP server's certificate is
validated. There is no option for ignoring the certificate check.
Requires user role: ADMIN
Default value: Off
Value space: Off/On
Off: Disable SMTP (and email) support.
On: Enable SMTP support for sending email.

NetworkServices SMTP Server

This is the address of the SMTP server.
This setting is used only if the device is registered to the Webex cloud service.
Requires user role: ADMIN
Default value: ""
Value space: String (0, 255)
A valid IPv4 address, IPv6 address or DNS name.

NetworkServices SMTP Port

This port is used for outgoing emails from the device to the SMTP server.
Set a port number based on the encryption setting (NetworkServices SMTP Security) and
the requirements of the SMTP server. Do not use the default value.
This setting is used only if the device is registered to the Webex cloud service.
Requires user role: ADMIN
Default value: 0
Value space: Integer (0..65535)
The port used for outgoing emails from the device.
D15362.17 DX70 and DX80 Administrator Guide CE9.14, OCTOBER 2020.
Configuration Peripherals Maintenance

NetworkServices SMTP Username

This is the username part of the credentials that are used to authenticate the device with
the SMTP server. This setting may be required by the SMTP server.
This setting is used only if the device is registered to the Webex cloud service.
Requires user role: ADMIN
Default value: ""
Value space: String (0, 80)
A valid username.

NetworkServices SMTP Password

This is the password part of the credentials that are used to authenticate the device with
the SMTP server. This setting may be required by the SMTP server.
This setting is used only if the device is registered to the Webex cloud service.
Requires user role: ADMIN
Default value: ""
Value space: String (0, 64)
A valid password.

NetworkServices SMTP From

When sending an email message from this device, this is the name of the mailbox that the
message is sent from.
This setting is used only if the device is registered to the Webex cloud service.
Requires user role: ADMIN
Default value: ""
Value space: String (0, 255)
An email address that meets the requirements of the SMTP server.
www.cisco.com — Copyright © 2020 Cisco Systems, Inc. All rights reserved.
116
Administrator Guide
Device settings Device settings Appendices