Network [N] Ieee8021X Anonymousidentity; Network [N] Ieee8021X Identity; Network [N] Ieee8021X Password; Network [N] Ieee8021X Tlsverify - Cisco Webex DX70 Administrator's Manual

Cisco Webex DX70 and DX80

Introduction

Network [n] IEEE8021X TlsVerify

n: 1..1
Verification of the server-side certificate of an IEEE802.1x connection against the
certificates in the local CA-list when TLS is used. The CA-list must be uploaded to the
video conferencing device. This can be done from the web interface.
This setting takes effect only when Network [1] IEEE8021X Eap Tls is enabled (On).
Requires user role: ADMIN, USER
Default value: Off
Value space: Off/On
Off: When set to Off, TLS connections are allowed without verifying the server-side
X.509 certificate against the local CA-list. This should typically be selected if no CA-list
has been uploaded to the device.
On: When set to On, the server-side X.509 certificate will be validated against the local
CA-list for all TLS connections. Only servers with a valid certificate will be allowed.

Network [n] IEEE8021X UseClientCertificate

n: 1..1
Authentication using a private key/certificate pair during an IEEE802.1x connection. The
authentication X.509 certificate must be uploaded to the video conferencing device. This
can be done from the web interface.
Requires user role: ADMIN, USER
Default value: Off
Value space: Off/On
Off: When set to Off client-side authentication is not used (only server-side).
On: When set to On the client (video conferencing device) will perform a mutual
authentication TLS handshake with the server.
D15362.17 DX70 and DX80 Administrator Guide CE9.14, OCTOBER 2020.
Configuration Peripherals Maintenance

Network [n] IEEE8021X Identity

n: 1..1
Define the username for 802.1X authentication.
Requires user role: ADMIN, USER
Default value: ""
Value space: String (0, 64)
The username for 802.1X authentication.

Network [n] IEEE8021X Password

n: 1..1
Define the password for 802.1X authentication.
Requires user role: ADMIN, USER
Default value: ""
Value space: String (0, 50)
The password for 802.1X authentication.

Network [n] IEEE8021X AnonymousIdentity

n: 1..1
The 802.1X Anonymous ID string is to be used as unencrypted identity with EAP (Extensible
Authentication Protocol) types that support different tunneled identity, like EAP-PEAP and
EAP-TTLS. If set, the anonymous ID will be used for the initial (unencrypted) EAP Identity
Request.
Requires user role: ADMIN, USER
Default value: ""
Value space: String (0, 64)
The 802.1X Anonymous ID string.
www.cisco.com — Copyright © 2020 Cisco Systems, Inc. All rights reserved.
104
Administrator Guide
Device settings Device settings Appendices