Set Up Remote Monitoring - Cisco Webex DX70 Administrator's Manual

Cisco Webex DX70 and DX80

Introduction

Set up remote monitoring

Requirement:
• RemoteMonitoring option
Remote monitoring is useful when you want to control the device
from another location.
Snapshots from input sources appear in the web interface, so you
can check the camera view and control the camera without being
in the room.
If enabled, snapshots are refreshed automatically approximately
every 5 seconds.
Automatically refresh snapshots
D15362.17 DX70 and DX80 Administrator Guide CE9.14, OCTOBER 2020.
Configuration Peripherals
Check whether or not the device has the
RemoteMonitoring option
1. Sign in to the web interface.
2. Check the Home page to see if RemoteMonitoring is on the
list of Installed options.
If not on the list, remote monitoring is not available.
Enable remote monitoring
Install the RemoteMonitoring option key. How to install option keys
are described in the
PLEASE BE AWARE THAT IF YOU ENABLE THE REMOTE MONITORING
OPTION YOU MUST MAKE SURE THAT YOU COMPLY WITH LOCAL
LAWS AND REGULATIONS WITH REGARD TO PRIVACY AND PROVIDE
ADEQUATE NOTICE TO USERS OF THE DEVICE THAT THE SYSTEM
ADMINISTRATOR MAY MONITOR AND CONTROL THE CAMERA AND
SCREEN. IT IS YOUR RESPONSIBILITY TO COMPLY WITH PRIVACY
REGULATIONS WHEN USING THE DEVICE AND CISCO DISCLAIMS ALL
LIABILITY FOR ANY UNLAWFUL USE OF THIS FEATURE.
Maintenance
► Add option keys
chapter.
www.cisco.com — Copyright © 2020 Cisco Systems, Inc. All rights reserved.
166
Administrator Guide
Device settings Appendices Appendices
About snapshots
Local input sources
Snapshots of the local input sources of
the device appear on the Call Control
page.
Snapshots appear both when the device
is idle, and when in a call.
Far end snapshots
When in call, you may also see snapshots
from the far end camera. It does not
matter whether or not the far end device
has the RemoteMonitoring option.
Far end snapshots are not displayed if the
call is encrypted.