Cisco Webex DX70 Administrator's Manual page 76

Cisco Webex DX70 and DX80

Introduction
Factory reset the video conferencing device
We recommend that you back up the log files and configuration of the
device before you continue with the factory reset.
Factory reset DX70 using the mute and volume
buttons
Follow these steps to factory reset a DX70 on boot up. If the device is on,
press and hold the power button until the device shuts down before you
continue.
1. Locate the Mute and Volume up buttons (LEDs).
2. Press the power button, and pay attention to the
3. When the Mute button has blinked twice, press the
immediately followed by pressing and holding the
approximately 4 seconds. During this process the
red for a few seconds.
Wait while the device reverts to the default factory settings. The device
restarts automatically when finished. This may take a few minutes.
When the device has been successfully reset to factory settings, the
Setup assistant starts with the Welcome screen.
D15362.17 DX70 and DX80 Administrator Guide CE9.14, OCTOBER 2020.
Configuration Peripherals
(page 4 of 4)
Mute button.
Volume up button,
Mute button for
Mute button turns
Maintenance Maintenance
www.cisco.com — Copyright © 2020 Cisco Systems, Inc. All rights reserved.
76
Administrator Guide
Device settings Appendices
Mute
Volume up
Power button